Senseca OMNI-P1-020RK015IS Pressure Transmitter

Pressure Transmitter / Switch OMNI-P1Technical data Sensor Process connection Measurement ranges and pressureresistance● ● ● ●Analog output, two switching outputs Clear, easily legible, illuminated LCD displayModifiable units in the display Designed for industrial useCharacteristics The OMNI-P1 pressure transmitter / switch is intended for themeasurement of static and dynamic pressures in liquids and gases.It consists of a pressure cell as a sensor, and an integrated transformer.The sensor is an economical ceramic cell with a temperature compensated measuring bridge using thick film technology. It isprotected from damage because of its non-flush construction, and is built extremely robustly.The pressure present is shown in the display and output as an analog signal (0/4..20 mA or 0/2..10 V). In addition, if set limitvalues are fallen short of or exceeded, this can be signalled by means of two switching outputs and a red LED.Because the complete upper part of the housing can be turned, it is possible to simply and infinitely adjust the display and the cableoutlet.By turning the programming ring to right or left, it is simple to modify the parameters (e.g. switching point, hysteresis...). Toprotect from unintended programming, it can be removed, turned through 180 °, and replaced, or completely removed, thus acting asa key.dsh_fam_omni-p1_en_vs01 V1.01-05Measurement accuracy Repeatability Dynamics Working temperature Storage temperatureSupply voltage Power consumption Analog outputSwitching outputHysteresisDisplayElectrical connection Ingress protection Materials medium-contact Materials, nonmedium-contactceramic cell with measuring bridge using thick film technology male thread G 1/4 A, G 1/2 A(optionally with female thread) Range* OverBurst pressure** pressure barpsibarbar0.. 1 0… 14,5 5 6 0.. 2 0… 29,0 5 6 0.. 5 0… 72,5 7,5 15 0.. 10 0… 145 1530 0.. 20 0… 290 30 60 0.. 50 0… 725 75 150 0..100 0…1450 150 250 *Optional measurement ranges on requestAll pressure values relative (differential pressure to the environment) **The pressure transmitters may be loadedwith the specified overpressure < 1 sec.±1 % of final value;plus 0.05 %/K at < 0 °C and > 60 °C ±0.5 % of full scale value measurement cycle 32 ms, display cycle0.5 sec.-20..+70 °C (with gooseneck max. 120 °C) -20..+80 °C 18..30 V DC <1W 0/4..20 mA, 0/2..10 V via a 500 Ohmresistance after 0 V (impedance of the receiver > 100 kOhm) transistor output "push-pull"(resistant to short circuits and polarity reversal) Iout = 100 mA max.adjustable, for Min-switch, position of the hysteresis above the limit value, and forMax-switch, below the limit value backlit graphical LCD-Display (transreflective), extended temperaturerange -20..+70 °C, 32 x 16 pixels, background illumination, displays value andunit, flashing LED signal lamp with simultaneous message on the display.for round plug connector M12x1, 5-poleIP 67 stainless steel 1.4571, ceramic Al2O3, FKM stainless steel 1.4305 (housing), hardenedmineral glass, POM (programming ring), Samarium-Cobalt (magnet)1